Make sure you have a dry surface that is free of dirt, loose paint, rust, oil, grease, coal tar, silicone, or other contaminants. Apply using an 18" foam squeegee or roller (use a 6-12" brush for edges). Apply when temperature is above 10ºC/50°F and rising and avoid direct sunlight. Make sure what you’re coating is at least 5 degrees above the dew point of the environment you are coating in.

For cracks over 2 mm (1/8”), pitting, spalling, and small potholes, use an appropriate patching material. Fill all voids or cracks under 2 mm (1/8”) with Driveway Restore Sealant using a brush. Coat the edges of the driveway starting on the outside and then inward 6” to 12” with a brush to ensure a clean look. Allow to fully dry.

After the final coating has dried sufficiently enough to walk on and not cause damage, inspect the area for uniformity of membrane thickness and coverage. Ensure at least 48 hours (or until dry to the touch) of dry weather before allowing vehicle traffic.